I have a 79 c20,that put GM TBI on and got it running. I am having trouble changing VE 1 table, i got it to change once and it was too lean, when i tried to change a little the other way, it didn't change. i have done this on another car. Not sure what i am doing wrong. I downloaded the latest ver. of Tunerpro RT. still no change. Could use some ideas/ help??? I am using AKAJ bin for 87 5.7 rv .
After every .bin change save the file as new and update the name say VE1, then VE1.1 then VE1.2 etc.
Then be sure you are loading the latest .bin alteration each time to the buffer before programming the chip.
89 K1500 Scottsdale 5.7L 5spd 3:42 RamJet cam Dart iron TBI heads 427 PCM swap
95 C2500 Cheyenne 6.5L turbo diesel 4L80e 4:10 DB2-4911 Manual pump conversion 0411 PCM trans control 2Bar COS
05 Outback XT 2.5L turbo gas auto
Are you having trouble saving the changes to the bin, or are the changes not affecting the way the engine runs? Are you using the correct definition? Are you burning chips or using an emulator?
I think with everyone help i have got working now Thanks Gearheads
Posting Permissions
Reply With Quote
Bookmarks