Hi,
it seems you were right.I moulded the cables with wire mesh and grounded this. I remember we had this on gasoline driven cars in the army. At first glance (had no time to drive it) it looks good.
Attached a view pictures
Hi,
it seems you were right.I moulded the cables with wire mesh and grounded this. I remember we had this on gasoline driven cars in the army. At first glance (had no time to drive it) it looks good.
Attached a view pictures
I hope that does it! Looking forward to hearing about it after you drive it.
Hello, up to now its running without spikes in ignition.Here is how i did the isolation.
First i had a used water hose from the plummer.
next I cut both ends
when you press the mesh together you can easily pull out the inside.
Put a piece of a round wood inside the mesh, then you can put on some solder to the mesh.
next post!
solder a piece of wire to the mesh, it will be the earth point.
put some shrinking tube on the mesh
put the cable inside the mesh
shrink the shrinking tube on the ends of the mesh
reddy cable
build in with earth point
Bookmarks