Page 2 of 2 FirstFirst 12
Results 16 to 20 of 20

Thread: Are all the 8 pin ignition modules that same?

  1. #16
    Fuel Injected!
    Join Date
    Mar 2019
    Location
    Camarillo, CA
    Age
    47
    Posts
    82
    IT WAS MY D@MN ROTOR!!!!

    I have a buddy here in town that has another AMC 360 so I took my cap/Rotor/wires, and adapter (we run the Ford Duraspark wide cap) and went to his house. Intalled my cap/wires, his truck fired right up. I installed my rotor and adapter, his truck would barely start. Put all his parts back on except left my rotor and it backfired and sputtered just like mine. So I took all my parts home and borrowed his rotor and put them on my truck. It fired right up and ran like a champ!!!

    Now on to tuning! It was in closed loop pretty much the whole time and that is new too. WOO HOO!!! Thanks everyone for helping out!

  2. #17
    Fuel Injected!
    Join Date
    Nov 2017
    Location
    Californiacation
    Age
    57
    Posts
    811
    Awesome, I've seen quite a few that burn a minuscule hole through the rotor and sometimes idle fine but under load it takes the fire right to the shaft. Good testing.
    -Carl

  3. #18
    Fuel Injected!
    Join Date
    Mar 2019
    Location
    Camarillo, CA
    Age
    47
    Posts
    82
    Check this out! this is what the killer was! The indexing tab INSIDE the rotor was off about 10 dergrees! Here's the bad one:
    wrong.jpg
    Here's the good one:
    correct.jpg

  4. #19
    Fuel Injected! PlayingWithTBI's Avatar
    Join Date
    Dec 2018
    Location
    Tonopah, AZ
    Age
    70
    Posts
    341
    WOW, nice catch! Which brand is which?

  5. #20
    Fuel Injected!
    Join Date
    Mar 2019
    Location
    Camarillo, CA
    Age
    47
    Posts
    82
    I have NNNNNooooo clue. I bought the bad one about a year ago and it was sitting on my shelf. The good one was my buddies he got from a wrecking yard.

Similar Threads

  1. Replies: 16
    Last Post: 01-26-2018, 03:30 PM
  2. Various PROMS and DRAC modules.
    By iscout62 in forum Buy - Sell - Trade - Wanted
    Replies: 18
    Last Post: 05-28-2015, 05:29 PM
  3. Knock Sensors and ESC modules
    By EagleMark in forum GM EFI Systems
    Replies: 2
    Last Post: 12-27-2014, 01:11 AM
  4. A question about DRAC/VSSB modules
    By Sideways in forum GM EFI Systems
    Replies: 11
    Last Post: 12-13-2014, 09:44 AM
  5. Two 7747's and two knock modules
    By JeepsAndGuns in forum Buy - Sell - Trade - Wanted
    Replies: 1
    Last Post: 02-26-2014, 02:27 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •