Fresh TBI Swap - No Start

[JCampbell]

Yep. I'm using Bowtie Overdrive's TV Made EZ kit for the TBI.

Screenshot_20190610-101406_Instagram.jpg

[stew86MCSS396]

Key on engine off, IAC should go to ~145. Perhaps IAC is wired wrong. You make no mention of using BBC throttle body but your pic w lack of ridge at the bore opening suggest that. Pay attention to IAC wiring here: http://www.gearhead-efi.com/Fuel-Inj...o-7-4-tbi-swap

Went back and read your older post saw that you have ultimate mods hence lack of ridge mention. Nonetheless, might want to check iac wiring if slammed shut key on.

[tayto]

a lower cost option to adapt a 700r4 to a BB tbi is to cut the bell crank off a SB tbi and weld it onto the BB throttle shaft. make sure your TV cable is tight @ WOT. i do this by attaching a smal pair of vise grips onto the little stop at the end of the TV cable. I adjust 1 click at a time until i have about 1/16" of TV cable "free play" while holding the bell crank at WOT. you dont want it so tight that it strains the cable. DO NOT rely on the self ractheting mechanism and "call it good" especially if you have an aftermarket shift kit install (transgo, etc). Also, a pressure guage is HIGHLY recommended to confirm pressure and more importantly instant pressure rise. What i mean: as you begin moving the throttle with a properly setup tv cable, the needle on your guage should immediately beging to build pressure.