Sorry if this has already been done but I originally used this thread to make an aldl cable that worked but was clumsy and needed a separate cable to connect to my PC: http://www.gearhead-efi.com/Fuel-Inj...USB-ALDL-Cable. Well that thread was too long so I decided a new write up with all the info in the first page would be better. I also lost my original ALDL chip and had to figure out a different one, so here it is:

Found the FT232RL cable on ebay for $3.00 and only had to wait 9 days to get it from China
Screenshot_20190324-000755_eBay.jpg
20190410_125245.jpg

Took the plastic cable end off:
20190410_125627.jpg

Popped open the USB end
20190410_125725.jpg

Clipped out all wires except the ground, RXD, and TXD
20190410_125945.jpg

Put the USB end back together with a few small dabs of superglue and then soldered the RXD & TXD wires together and the ground/blue wires and left a few wires to make the end stronger.
20190410_131556.jpg

Squished the connectors down a bit to fit into the ALDL port and added heat shrink and it works great
20190410_133206.jpg