I am having trouble getting my VSS signal to my computer.

Hardware:
VSS: Dakota Digital SEN-01-4160, driven by my speedo cable
Translator: SGI-5E, Black VSS wire to Sensor ground, Grey to Signal, ground to body ground, 12v to pink/black, Output 5 to F12
Computer: 16197427, am on $OE but going to $OD,
Tuner: Laptop running TunerPro RT, Red Devil River Bluetooth ALDL

What I've done and indications:
Key on and SGI-5E powers on. I set it to L-L wtih no calibration changes. When I drive it, I see the LED flash on the display so it's getting a signal but TunerPro shows no speed. I verfied continuity across Output 5 to Pin F12.

I removed the VSS and spun it with a drill and watched it put out 2+volts A/C so the sensor seems to be working.

Is there a setting I am missing? Should be in Output 5 for 2000PPM for this computer, right?