Can anyone add a few things on an adx?

**cgw** · 10-03-2018

I'm running OD maf on a 7427, I have no prob tuning it however my O2 voltage on my logs always shows zeroed out, and I'd also like knock counts to be able to be displayed as well. Tuning I understand, the pid/address/hex stuff I do not. I can upload my xdf/bin/adx if anyone can add those capabilities

**cgw** · 10-03-2018

Here are my BIN, XDF, and ADX I'm using

**notime2d8** · 10-04-2018

Here you go. Let me know if it works for you. I also added a MPG calculation as well. I only made 2 edits to the bin ALDL table And 4 edits to the ADX

**cgw** · 10-05-2018

Awesome, thank you! Everything is working great, except the MPG shows some wonky numbers, it either runs around 2 MPGs or around 50 MPGs. Now, if I can get my IAT working right, I'll be happy

**notime2d8** · 10-05-2018

Originally Posted by cgw

Awesome, thank you! Everything is working great, except the MPG shows some wonky numbers, it either runs around 2 MPGs or around 50 MPGs. Now, if I can get my IAT working right, I'll be happy

Does your Speed and MPH show correctly in the data-log? And it's instant MPG, so it would be high when coasting and low at WOT. And is the IAT a wiring issue or it's not working on the PCM? I have mines connected but didn't know how to use it in my tune. You think it uses the MAT fields? I may use it this winter if so.

**cgw** · 10-06-2018

speed and mph both show correctly, but its actually showing higher mpg during acceleration and high speed and lower numbers coasting. Im pretty sure when its working and enabled it uses the mat fields to scale your enrichment and enleanment tables to avoid the cold/lean and hot/rich issues if you tune for operating temp