Hi guys,
Is it common to get a crease in the VE table?
I'm finding when i cruise & lift and go into decel, the AFR gauge just maxes out.
I'm getting a crease in the table about 30 map where I'm having to ramp up the VE cells again.

The car does seem to be improving.
Anytime there is some load it's fine it's just at the point you hold/lift the throttle & vacuum rises (map in 15-35 range).

I've just raised the IAC vs Vehicle speed & IAC park position to see if letting more air in will reduce the high vacuum reading on decel.
Not had a chance to test this out though.

Any other ideas ?


Thanks
Mitch