Quote Originally Posted by bgott View Post
As the design belongs to Dave I am not at liberty to produce these. I will say I have had it on the engine now for 2 years or so without any issues and seems to work fine. I would recommend Dave get them produced and market the design but in truth the amount of machining required may make it not feasible in terms of price to demand. When you consider cost to produce would likely be around $300-400 per part youre halfway to buying a holley sniper at that point.
The adapter could be affordably manufactured Off-Shore (at or about the Trans-Dapt prices . . . https://www.hedman.com/carb-to-efi-adapters), minimum production run of 1000 units. My pocket$ are not that deep. Trans Dapt isn't buying my idea either

dave w