1227747 question

[Fast355]

I don't. I've been doing my homework on them. I gather that the cable adapter type works best. I figured I could tune it to run/idle before working on the VSS part but, I've read in a few spots that it's best to get it in before tuning.

I went hunting and found another '7427 with a stock BCC BJLF. Had the MEMCAL too. So at least I know I am starting with a proper match with my mask. I think I am going to stick with the $OD. It seems to have the most options

Stick with $0D, perhaps look at the timing table for BNKM which is the 1-ton 350/4L80E van. IIRC it is a $OE file.

As for the speed sensor the newer PCM only needs the speed signal input into the 2,000 ppm input if you are running without an E-trans. That means your vans stock VSS signal can be plugged right into the PCM and good to go. You need to disable the Computer Controlled Automatic flag in the options and Enable the TCC ONLY flag.

[Jadgsxr]

You need to disable the Computer Controlled Automatic flag in the options

I couldn't find this option. Am I going blind too ?


2.txt