Thank you for the replies!.... I spent a couple of hours in the burb dash today working on deconstruction.... It looks like I'm going to need to pull the dash apart completely to get the complete harness......A while back I de-constructed a 91 wagon and pulled 100% of all wiring out and started verifying wires and routing and had the entire floor of the 2 car garage covered with wires....Decided to do it later when I installed the 305 into the van, but changed the plan to this 454...…..I guess the way to do it is to get the engine, trans, and necessary components in place and then lay the harness over the whole setup and start connecting and pruning (?)……. By the time I get to that point, I'll probably want to just buy that harness from fuel injection connection....