Thread # 2, fuel line question

[skandolis]

You talk about the tool to press the ends on. What does it look like and where do you get it? I made a few connections by just heating up the barbed end and sliding the plastic line over it. When cool it seems to shrink down and seal, but I haven't put pressure to it yet.

20180315_082227[1].jpg


tool looks like this, it isnt really necessary though, just makes things way faster, alternatively, you can drop the line in boiling water, then push the end in while its still hot, boiling water works for making bends too, just wrap a spring around where you are making the bend to keep it from collapsing when you are bending it....