1995 lt1 M6 tuning

[steveo]

it wasn't an AEM i used before, it was an innovate LC series gauge

this is the key to getting decent output from that gauge, just set a narrow AFR range from 0-5

[Jonas_Ohman]

Soo, last night i finally got some time to do some WOT tuning, but, I wasn´t able to make any changes in TunerPro.

This morning i tried to change the .XDF file for an otherone (after i reinstalled TunerPro), and then it was possible...

Anyone else who experienced this?

EEX.jpgEE.jpg

[steveo]

eex good.

whatever other one you were using...bad

[Jonas_Ohman]

I forgot to mention it´s the same bin, different values depending of which XDF I´m using.
The EE XDF is from TunerPro homepage.

Now I don´t know which to use, but the EEX doesn´t allow me to change the table, and as far as I have seen it´s the only table that doesn´t work correctly for me.

I attatched the .BIN, if anyone have the time to take a look of it...

//Jonas

[steveo]

works fine for me with EEX

[Jonas_Ohman]

works fine for me with EEX

No problem with values? If I write 0 in the RPM table, save and then open the same table, the value has changed to 0,5...