1995 lt1 M6 tuning

[spfautsch]

it was a long time ago and a borrowed unit? it had a serial cable for configuration. you could set the 0v=AFR and 5v=AFR, so you could use 9:1-16:1 ...

After quite a bit of searching I've been unable to locate anything they're currently selling that is configurable over serial. They do make a 4 channel controller that can be configured over CAN but it's awfully pricey.

Thinking I'm going to buy one of these gauge setups - they appear to be quite a bit cheaper for the same functionality as the "inline" setups. I would assume this is because the electronics for the gauges don't need to be weather resistant.

[kur4o]

I got an Innovate mtx-l unit. It does have logging capabilities through serial and can be configured. I don`t recommend it since after not much use it produce some electrical noise on the radio.
The best way to log will be through serial integration over com port. Not sure how hard it will be to add that in eehack.

[Eds]

After quite a bit of searching I've been unable to locate anything they're currently selling that is configurable over serial. They do make a 4 channel controller that can be configured over CAN but it's awfully pricey.

Thinking I'm going to buy one of these gauge setups - they appear to be quite a bit cheaper for the same functionality as the "inline" setups. I would assume this is because the electronics for the gauges don't need to be weather resistant.

Look at the wideband controllers sold by Ecotrons. May be what you are looking for.
http://www.ecotrons.com/products/accurate_lambda_meter/

[steveo]

it wasn't an AEM i used before, it was an innovate LC series gauge

this is the key to getting decent output from that gauge, just set a narrow AFR range from 0-5

[Jonas_Ohman]

Soo, last night i finally got some time to do some WOT tuning, but, I wasn´t able to make any changes in TunerPro.

This morning i tried to change the .XDF file for an otherone (after i reinstalled TunerPro), and then it was possible...

Anyone else who experienced this?

EEX.jpgEE.jpg

[steveo]

eex good.

whatever other one you were using...bad

[Jonas_Ohman]

I forgot to mention it´s the same bin, different values depending of which XDF I´m using.
The EE XDF is from TunerPro homepage.

Now I don´t know which to use, but the EEX doesn´t allow me to change the table, and as far as I have seen it´s the only table that doesn´t work correctly for me.

I attatched the .BIN, if anyone have the time to take a look of it...

//Jonas

[steveo]

works fine for me with EEX