i understand that but i dont see a mask labeled as $F1
i understand that but i dont see a mask labeled as $F1
My apologies, I posted the wrong link try this link: http://www.tunerpro.net/gmOBDI.htm
You will need to know your engine code, for example LN2, LM3, LD2 ... LG0
dave w
so right now im running the a167 file which is correct for the ecm and im running the $F1 file. Ive tried the 3 different bins thats listed as well as all 3 bins. It shows that its connected but then flashes error and connected and error and keeps doing that. i also do seem to see any data.
i was trying to 5 which was a open port. I switched it to 2 and it made no change. also im not seeing any data be displayed. i also noticed this xds is for a 94-95. im not sure if thats causing the issue. mines a 93.
Last edited by metallica21156; 12-24-2017 at 12:03 AM.
its the 16134847. same style of programming and both dont use a chip.
Bookmarks