Data logs didn't upload...trying again.
Data logs didn't upload...trying again.
Does it flash out any error codes for checksum failure
Delco, I am new...very new...to tuning and using TunerPro. I did not notice any specific codes for checksum failure. There were NO flashing Codes. I checked by shorting Pins A & B on the ALDL. Would I see that in TunerPro?
Also, when you put the 28 pin ZIF socket in, did you solder pins 1,2, 26-28 together as seen in this picture?
http://www.gearhead-efi.com/Fuel-Inj...4&d=1404856990
Last edited by damanx; 12-03-2017 at 10:39 AM.
damanx,
Yes, those were the pins that I soldered together.
Bookmarks