Results 1 to 2 of 2

Thread: Newbie

  1. #1
    Carb and Points!
    Join Date
    Oct 2017
    Posts
    1

    Newbie

    1992 Corvette LT1 six speed.
    Bought an ALDL (GM OBD1) Cable with 12 pin Connector USB from OBD Diagnostics.
    Installed Tunerpro RT.
    Installed the drivers.
    Downloaded the DA2.xdf and imported the DA2.ads into Tunerpro.
    I'm not sure which jumper setting I need or if I need anything else, right now I have set to the A and B shorted position. When I turn the car to the on position the cooling fan starts as if I jumped it to read the SES blink codes, it blinks one-two as normal.
    I watched a few videos and did some research but I'm missing something. I remember reading about a bin file but one isn't listed the file section at Tunerpros website so I'm not sure if I need one or not. That and still not sure about the settings. When I initialize Emulation Hardware while the cable is connected I get "initializing hardware" but just hangs there and the program freezes. Can anyone point me to a good tutorial or help me out?

  2. #2
    Fuel Injected!
    Join Date
    Jul 2016
    Location
    Weatherford, TX
    Age
    43
    Posts
    70
    It sounds like you are missing several pieces of hardware. The ALDL cable will only allow for data and resetting trouble codes.
    1994 Chevy G30 Van "Big Blue"
    5.7 TBI, Vortec Heads, Summit Intake, Thorley Short Headers with dual 2.5" exhaust, 4L80E transmission

Similar Threads

  1. help a newbie!
    By trickster555 in forum TunerPro Tuning Talk
    Replies: 5
    Last Post: 03-21-2016, 02:51 AM
  2. newbie.
    By pumasixtynine in forum Introductions
    Replies: 1
    Last Post: 10-10-2014, 05:39 PM
  3. Newbie from KY
    By k2500 in forum Introductions
    Replies: 2
    Last Post: 08-27-2013, 08:33 AM
  4. Newbie From Pa
    By Pete K in forum Introductions
    Replies: 0
    Last Post: 08-03-2013, 03:42 PM
  5. newbie from NC.
    By streetperf in forum Introductions
    Replies: 3
    Last Post: 07-22-2013, 04:16 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •