Quote Originally Posted by lionelhutz View Post
You can get a sensor from AIP Electronics. P/N is OS95LT and they cost about $55.

If you're going to put trigger wheels on the engine then might as well add the coil wiring harness and do the 0411 PCM conversion.

Note that the crank turns 2X for every cam rotation. So, you could move the high resolution 1* signal to the crank but would need to use 180 teeth instead of 360 teeth. You can't put the low resolution signal on the crank, it has to be on the cam.
It would be easy to do the 0411 PCM conversion, but I guess I am being cheap and trying to keep the LT1 PCM