DIY LTCC or similar system for LT1s

[Aroberson77]

I have a copy of the diagram. Do you want me to send you a convertor?

if you want, the diagram would be great as well

[buddrow]

Most of what you want can be done with software, and you wouldnt need delteq hardware(which is likely supported by accompanying firmware). The coil driver hardware is easy, the software, on multiple cylinders is easy although the arduino would be taxed during higher rpm operation, looking at microseconds to process dwell time before the next trigger pulse is received.

Bud

[Tom B.]

The delteq was the work around because of the driver issue. The system was developed over a decade ago. The beauty of the system was no programming changes were necessary. The average guy could install it in about an hour.
The tuning community has grown quite a bit since this stuff was the hot ticket.

[Tom B.]

Aroberson77
You have a PM