Been meaning to upload this for a while, but just kept forgetting. But finally did. Heres a short vid of the MTX-L gauge I installed. Sorry about the glare on the gauge face, the sun was not working in my favor that day.
You can hear me floor it a couple times, I also let off and go dfco a few times, you can see it go full lean. Also when I floor it and go into PE, it doesnt drop to 12.5 right away, it takes a couple seconds. I have the delay set to zero, and the datalog dash shows PE as soon as a floor it.
Also seems to run a tiny bit rich, even though I was up to temp, in closed loop, and have a heated o2.

There close to the end, when I floor it, when I finally let off, I think I was doing about 80 Not bad for a hair over 2.5 tons of steel...lol