Is the 16197427 ECM advanced $OD TP5 v 251 set up for a wideband connection at B16 ?
Is the 16197427 ECM advanced $OD TP5 v 251 set up for a wideband connection at B16 ?
You will first need to follow the instructions in the $OD TP5 v 251 .xdf for getting the Wideband O2 information into the data log. The 16197427 Does Not use Wideband information. You ONLY need a Wideband O2 sensor for Tuning.
I like using the AEM 30-4110 wideband gauge because it is Plug-N-Play when using the 16197427 PCM: http://aemelectronics.com/files/inst...GO%20Gauge.pdf
You will need to weld in a new O2 sensor bung into the exhaust pipe and install the wideband O2 sensor (you still need the original 16197427 O2 sensor) The wiring is very easy on the AEM 30-4110, connect B16 to the White wire from the AEM 30-4110, then connect the Red wire to ignition (both on / start) and black to ground (battery -). That's it, Plug-N-Play.
dave w
Dave ; Thanks for the info. You are right on and using the same stuff I am. I finally remembered where that info is found. In tunerpro it is in scalars under wbo2 datalogging. It gives complete instructions on how to set up for datalogging.
Bookmarks