red devil blue tooth problem

[MQQN28]

Dom
been away for a few days.

This seems to be where I was at one stage. The red devil is not seeing the data stream. My problem was I reversed the 160 and 8192 terminals when I wired up the ALDL socket my ECM an 808 160 baud. But this should not be your problem. The other thing I have just read is that the RED Devil does not like a pin on both E (160) and M (8192) of the socket. I'm not familiar with your ecm I take it is 8192.

On my system I know the data stream is running because the CEL light flashes, this seems to be what you get with the 10K resistor. The 10K resistor will start the data and can be removed. With 8192 it would appear to be full on.

I'm looking for some information I have on the red devil showing the led status, I have missed placed it.

I'm at the stage where I am receiving data but its not going where it should, I'm playing with the adx file.

Are you able to check if the data stream is getting to the right pin?

The other thing I'm using a Samsung S8 also and it seems to be working.