84Elky,

Here is what I got.
20170606_180818.jpg

20170606_180831.jpg

20170606_180852.jpg

20170606_180920.jpg

Before pulling the memcal, I removed the ecm from the jeep. I will re-run it tomorrow and see if I can get the codes to flash through the cel.

On the PS.

Good call on the TPS voltage. I completely forgot about that. It is currently set to .55 volts. I haven't set up the IAC yet, but thats another task after this stalling issue. The VSS will be hooked up. I started a thread on here about feeding the 7730 from a 40 tooth tone ring. Abandoned that idea and I'm going to run the 40 pulse per driveshaft revolution through a DRAC. Going by information from the other thread, I'm going to have the guy who burnt my chip uncheck magnetic vss attached and I should be golden!