Hello

Got the fuel ok by now bit by bit...
First the low throttle, now started to the higher throttle...
Almost all the BLM's between 126 and 130....

Noticed that when I go full throttle, the ecm goes into open loop....
Could someone tell me if it is possible to add conditions to the history tables....
That way, I could ignore the values when goes out of closed loop.....

Searched for it on this forum and on the internet, but didn't find any of this.....

And one more question, but the car did this since I got it... (even with the 3.1 engine)
When the engine is hot, it somethimes struggle to get it started....
Seems like I hear a little 'ping' sometimes too....
Advance is pre-set to 10°, starter engine is new, and also the cable from the battery to the starter is new..
Battery is good.
Only this that stays the same is the distributor... (cap and rotor is new, cables and plugs also new)
So I guess I could narrow it to the ignition module....
Could this be faulty? What should be the other symptoms then?

grtz, D