Results 1 to 15 of 37

Thread: 5.7L running too lean (very high NOx), won't pass state emissions

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #31
    Fuel Injected!
    Join Date
    Mar 2017
    Posts
    21
    Hey I am providing an update. I received and installed the 1227747 ECM with the factory ASDU chip. It started right up and after a warm up period I disconnected the distributer connector and set the base timing to exactly 0 degrees TDC. Previously, it was 2 degrees advanced. Then i ran TunerPro and created another log file. There seems to be some significant improvements. First it idles at 750 or so instead of 1150, but much more importantly at part throttle is now seems to be operating much better flipping back and forth every few seconds between Lean and Rich and the O2 sensor output voltage also seems to be alternating above and below .500. Previously, part throttle seemed to stay just Lean most of the time.

    I do have one question though. The vacuum and MAP numbers seem to pretty much remain constant regardless of throttle position. I don't understand this. Shouldn't the vacuum and MAP numbers drop as throttle increases?

    If someone could look at the attached XDL file it would be appreciated.
    Lee
    Attached Files Attached Files

Similar Threads

  1. Failed Emissions Test - High NOx
    By paulo57509 in forum Gear Heads
    Replies: 8
    Last Post: 07-21-2016, 10:53 PM
  2. Replies: 6
    Last Post: 03-09-2016, 08:19 PM
  3. Howdy from the Cowboy State
    By 39Ratrod in forum Introductions
    Replies: 4
    Last Post: 02-09-2016, 07:24 AM
  4. Replies: 52
    Last Post: 11-08-2014, 02:24 AM
  5. WTB pass side TPI serpentine bracket
    By mtrhead in forum Buy - Sell - Trade - Wanted
    Replies: 3
    Last Post: 09-12-2014, 05:29 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •