Narrowband Tuning Tool

[maxpowerta]

Perfect! that did the trick, thanks. One observation I've made and I'm not sure if you intended it to be this way or not but, Every time you press "redefine input" and then go back and reprocess the log. The parser log does not reset, under "filtering" it just keeps counting up. This caused me some confusion when i noticed the # of discarded records exceeded the total number in the log.log.JPG

[steveo]

ah, thats a bug. i'll fix that.

[dud]

Here are some pictures comparing Tirmalyzer with my spreadsheet using the same filters.

EDIT: This is with an ALDLDroid log using $E6 mask. Added the log I used.

[steveo]

thanks very much for that detail. the data looks pretty decent

does your spreadsheet use integrator data? to make the comparison for error checking you might have to disable it. the new version will have a toggle for it. otherwise looks pretty good.

also feel free to play with the hystersis values in advanced settings to tune "loose cell" mode

[steveo]

oh and the wb data is likely quite different due to the 'minimum records' setting in advanced

it writes off a cell as junk based on trim behavior so might have to lower it when analyzing small wideband data sets

[steveo]

0.9 BETA:
- some code cleanup and general optimization
- ammended dictionary
- fixed bug where filter statistics were not reset
- ignore integrator in arbitrary input mode
- add option to more easily ignore integrator
- add option to use leanest trim in dual bank configs

.... you should know where to get it by now

[dud]

thanks very much for that detail. the data looks pretty decent

does your spreadsheet use integrator data? to make the comparison for error checking you might have to disable it. the new version will have a toggle for it. otherwise looks pretty good.

No my spreadsheet doesn't use Integrator data. I hadn't thought about the integrator. I ran the log again with the integrator disabled and got the exact same numbers in all three modes as if the integrator was enabled. Another bug maybe?

I'm still impressed with the data. The data presented is after using Trimalyzer to tune my ve's with the "Geometric" method. I also used it to adjust my PE AFR (WBO2), and the output on the dash gauge is more in line with your tool than my spreadsheet. Go figure.

[steveo]

my tool uses the integrator data but not in its entirety, it just skews the blm value with it slightly to get pre-learning and inter-blm-cell type data. this is done with a reduction multiplier, it's in advanced settings. TUNE_INTEGRATOR_REDUCTION. by default 38%