I have a 1995 Chevy 5.7L crate motor mated to a 700R4 trans in a 1989 Jeep Wrangler. ECM (1227747), wiring harness, and all sensors are probably out of a 91 or 92 chevy truck (I didn't do the original build). The 1227747 ECM was used because the 700R4 trans is non-electronic. I have TunerPro5 RT and Moates Extreme ALDL setup with 42.ads (imported and converted) to .adx file. Data is streaming fine but I only see 13 total parameters in the list view. (see attached screen shot). I expected to see many more. Specifically, I am looking for Loop Status, P/N Position Switch, BLM, and EGR parameters. I have looked at lots of tutorials but have not found how to add parameters the TunerPro RT lists. Anyone know how to do this?