Yes, the bypass uses the heater core exactly as explained in my post and the referenced post. You muddied up the requirements for a bypass by posting the "you do not need a bypass of any kind" statement regardless of the intention. On a Vortec engine (not just using the heads but the newer block too) there MUST be an external coolant loop in place to perform the bypass function.
The OP also asked about NOT running the GMPP manifold.
That depends on what water pump you use. The Vortec block I built had the passageways and with the older water pump, simply drilling the head provided for the correct coolant bypass. Actually if you simply use the Vortec heads even on an older block it will block off the bypass!
Thanks everyone for the feedback but Jegs called to verify order and I was so confused I chickened out on the vortec and changed my order to a Lo5 engine that came stock in the old burb. It will be much cheaper and faster to get going again. I know it is not close to as good an engine but it has been sufficient for years.
I may try some tuning on it and get some experience and at a later date try the vortec and sell the lo5
Bookmarks