sounds like e-side isnt booting.
obviously the t side is good to go if we van connect and get the vin, etc
sounds like e-side isnt booting.
obviously the t side is good to go if we van connect and get the vin, etc
Cool. I'll retry seating the others side then tomorrow.
That error was the message I got after it stiffed it originally.
'95 Z28 M6 -Just the odd mod.
'80 350 A3 C3 Corvette - recent addition.
[QUOTE=Terminal_Crazy;63738]Cool. I'll retry seating the others side then tomorrow.
That error was the message I got after it stiffed it originally.[/QUOTE
Tside seemed ok
Took the E side out. Bent the pins out. scraped them clean & hammered back in.
Connected. Flashed. Run. Logged.
She just keeps getting scarier.
BIG THANKS Steveo.
Thanks
Mitch
Terminal Crazy
'95 Z28 M6 -Just the odd mod.
'80 350 A3 C3 Corvette - recent addition.
yipe! i wish those sockets weren't so sketchy, it would suck for that thing to dislodge when you were in a hard corner or something.
I have the same issue to fix, coud you share the bin files you used to program the chips? The ones that are on this site are not working...
[EDIT] Nevermind, I got it worked. Needed to bend up pins on PLCC socket and it started :)
Last edited by dzidaV8; 06-17-2017 at 06:04 PM.
Sent Last night anyway!
Due to the "Internet" losing history over time it's always a good thing to spread copies around !
Mitch
'95 Z28 M6 -Just the odd mod.
'80 350 A3 C3 Corvette - recent addition.
Bookmarks