Today I tried to do some logging with P.E. disabled to check my MAF calibration in the higher AFGS ranges. I changed the "PE enable min MAP" setting to 255 (which resets to 108 after saving for w/e reason) and went for a drive. I noticed that my target afr would drop to 12.2:1 after a few seconds of WOT and EEHack didn't log many of the higher AFGS values. Nothing showed that I was entering PE mode but I assumed that it would try to maintain the 14.10 AFR commanded in the "Stoich AFR target" setting. Is there more to disabling PE mode than setting the MAP boundary out of reach? On the plus side my cell 15 BLMs were 128 & 129