60 chevy pickup

[Robin1955]

we have a 1960 chevy apache we are restoring. we are going to put a 95 350 tbi engine in it and we need to know about wiring harness and what ecm

[dave w]

Most of the information you are looking for is posted in the link below:

dave w

http://www.gearhead-efi.com/Fuel-Injection/showthread.php?303-16197427-PCM-Information-0D

[Robin1955]

Thanks, this is enough information to get us started

[89S10_Project]

I was just reading about folks putting one of those truck bodies on an S10 chassis. If you got a 2WD 4.3 truck, it's pretty easy to toss in a V8 and run it off the same ECN- your ECM mods could literally be plug and play if you went with a TBI 4.3 to a TBI 5.7 (literally unplg the 4.3 ECM and plug in a 5.7 ECM, or if you wanted to get complicated you could swap out a few chips.

I've done a 4WD V8 swap in an S-series, it wasn't that hard (do bear in mind my 4WD system at the time wasn't factory- I went SAS first). Apparently an advantage of going with the S-series frame swap is that you get modern braking, steering, suspension, etc, all in one fell swoop, while only really having to design body mounts.

[Robin1955]

thanks for the information, we already have the chassis and body all set just need to make ecm and wiring work. i never thought about using a S-10 chassis.

[89S10_Project]

Cool, I'd love to see some pics!