stupid tuner pro rt question

[chris989]

Hello all,

It has been a few years since i used my tunerpro and auto prom and for the life of me i cannot figure out how to burn the chip. seams like something is missing from the toolbar.

I can upload/download the bin to the bin to the emulator but i can not remember how to burn it. I have been running off the emulator for 8 months now and can not find my OEM stock chip.


Don't laugh, please help.

Thanks,
Chris

[sturgillbd]

Tools, Hardware Utilities, Moates PROM I/O. Should bring up built in flash and burn software.

HTH,
Brian

[chris989]

Brian,

Thank you,

I might have a bigger problem now than that. When i hooked it back up to run off of the auto prom, nothing reads or changes with a bin upload. It is running poor and not reading the bin. I drastically changed the timing in the bin while emulating and no change.

Also, I use win aldl to data log and i can not get a stream from that port now.

Later tonight i will burn the chip and try to install it directly and see what happens.


Is it possible to fry a TBI computer?

Chris

[sturgillbd]

Make sure you have the cable oriented correctly on the APU1 and where it plugs into the ECM.

[chris989]

I have the notch in the chip/red strip on the emulator cable towards the edge of the ecm/computer. I did flip it towards the center and got a fast flashing check engine light so i flipped it back.


the notch in the chip should be point towards the edge of the ECM?

[Six_Shooter]

Also make sure you have checksum disabled, otherwise you'll experience similar results to what you have been.