A stepper motor like the IAC need to have power and ground applied to different terminals to make the armature turn a complete revolution. Look at the gm wiring diagram for your system and you'll see two connections for coil A and coil B. Each of these needs to be connected to 12V in turn on order to make the IAC move. When the ECM shows IAC counts, that's how many times the ecm has applied power to one or the other coils to make the IAC move. I have an old tool made by Thexton but I couldn't find it in their current tool lineup. Here's a thread that gives a homegrown way to check the IAC: http://www.chevytalk.org/fusionbb/sh...96c4b37436442/ There's also a mention of an OTC3320 IAC tester but I really think those old tools are only going to show up in Ebay auctions or swap meets now.