injector change- tpi - $6E

[bdads]

looking for some advice,,,,
just installed my 30lb injectors on my 377 stroker ,,,
trying to find out what and where i have to change info in the bin file to adjust for them ,,, they are bosch dark orange color 4 hole injectors-- if that matters

im using the aujm bin fom the $6E section of the forums--- and could use other bins from there too if needed,,,

this thing runs way terrible since the injector change ...way rich --

plus i added a wide band o2 ,, wired it up to the original sensor lead also,,, used the 0. to 5. volt side to go to factory end

was running 305 factory injectors---- actually didnt seem to run too bad with the stock ones----

but early yet just broke this engine in ,, trying to get it dialed in now .... thanx guys

[bdads]

actually more of a brown color --- I believe they are the bosch 3's.... trying to figure out what values to change in the bin.... thanx

[Kitch]

Have you seen this http://www.gearhead-efi.com/Fuel-Inj...d-part-numbers?

[bdads]

thanx,,, im looking for tpi injectors info....bosch 3's... and trying to find the values to put into the voltage area of the bin... ive seen others have done this-- just dont know where they came up with the info..thanx again