Hello Good Day My Dear
please can you convert tis file to bin
information : engine LS1 5.7 V8 4l60e
Here is it
Attachment 10710
Thank you Jeff.
Hello Good Day My Dear
please can you convert tis file to bin
information : engine LS1 5.7 V8 4l60e
Here is it
Attachment 10710
Thank you Jeff.
There are two 2002 Express van bins here:
http://www.gearhead-efi.com/Fuel-Inj...ll=1#post18585
One is a 4L60, the other is a 4L80.
thank you LRT for quick answer but all of that is coded by tunerpro software
and Mr dave w you are right
I want that file for ls1 pcm and i found bin file for ls1 and i programed directly to the chip but engine does not run
my problem is VATS ,Car starts and immediately dies
I have raw bin file and I don't have hptuners and efilive interface , i cant buy that
If i have another way to disable that security system please tell me
I thinking i need raw bin file that VAT was disabled
I transplants engine and now does not run
If you can please help me
here is my pcm file
Attachment 10713
Many Thanks
Last edited by okay; 07-11-2016 at 12:52 PM.
The tune that you attached to post #13 is corrupt, as is the bin that you attached to post #16.
I would not recommend using either of these.
What are you using to flash the PCM ?
What exact engine and transmission combination do you have ?
Better to answer these questions first, and then perhaps we can find a way to provide help that is actually useful.
The attached .bin is not Stock, use at your own RISK! I can't remember all the changes I did, but I'm sure I disabled VATS. Basically I flashed a PCM with the modified Corvette .ctz file I downloaded from Tune Depot. Then I read back the modified Corvette flash as a .bin file.
dave w
Thank you for posting the photos ... in this case a picture is indeed worth 1000 words !
The engine is a 24x CKP and 1x CMP (Gen 3), so the Express Van tune (4x CKP and 1x CMP) from post #13 will not operate this engine.
Whatever software you are using to read directly from the flash chip, is saving the raw data (bin file) in a unique order, which is not readily compatible with tuning software. This is why the bin in post #16 appeared to be corrupt. It is not corrupt, but rather just saved in a unique format.
You can only flash a bin file with your software, that uses this specific format. Do NOT flash any bins found on the internet using this software - the result would likely be catastrophic to the PCM.
Now that I know how your bin data is saved, I can work with this format.
What do you need ?
VATS turned off ?
Rear oxygen sensors turned off ?
Transmission mounted Gear Position Switch deleted ?
Just let me know ....
thank you for your information about ls1 and l31
software that i used to read chip is a programmer software . I can read,write,erase,and save file with that. image1
1-yes just i want disable VATS (turned off)
2-this engine doesn't have any oxygen sensor ( no oxygen sensor-first and rear sensor)even all the pins related to the sensor is empty in pcm and doesn't have MAF sensor
3-yes the Transmission mounted Gear Position Switch (selector or pnp) is removed image2
thank you
Bookmarks