Im using a Burn 2 with Tunerpro and a 27sf512 but Im using Flash & Burn to burn the chip. Dave sent me a starter bin file to put on the chip so I am taking that file directly to Flash & burn and onto the chip.
S3TPI said that the flashing CEL indicates that the ECM is not reading the PROM and the chip adapter connection may be at fault. I had an electronics shop install the ZIF socket for me; just trying to eliminate other possibilities before I take it back to them.
What did you find with yours, did you get it working?
checksum can make cel flash too...................
Checksum? What is that?
I'll try this, too.
I tried reinstalling the drivers and looked up how to disable checksum on Moates website. I made a separate bin file with checksum disabled. Also went back and checked continuity on all the ZIF solder connections including the 5 pins that get tied together. Still same issue.
Have you tried throwing a factory chip into the ZIF and seeing if it would still work? That should ensure that there were no problems introduced by installing the ZIF.
1973 K-5 Blazer, TBI 350, TH400, 1 ton axles & 38" SSRs'
1975 280Z, TBI 350, 700R4
1953 M-38A1, TBI Buick 231
1951 Ford Panel, 5.3 with 4L80E
Bookmarks