Right now they are firing off of the same pickup coil that has had 3 points of the 6 pickup points ground off. Basically a 3 cylinder engine. The odd cylinder Chip is programmed for 3 cylinders at 0 degrees base spark. The even cylinder chip is programmed for 3 cylinders with 90 degrees base spark advance. The base BPW has been reduced from 181 down to 135. The Bin is from a 4.3, the 198 fireball is a 3.2 which is 25% smaller. I decreased th BPW from 181 x .75 to get to BPW of 135. If the single pickup doesn't work I'll take the factory pickup coil out and put two pickup coils in at 45 degrees. Anything else you can think of that I will need to change in the programming for start up? I'll post up a couple of pictures, it's kinda messy because I rolled up wires and tied them instead of cutting the longer wires I may need.

Six, I really really really like the last line on all of your posts��