From what I'm told, an 896 and a 0411 are virtually the same - both 512k byte PCM's. The only virtue in a 0411 is that it logs things slightly faster.
Rick
From what I'm told, an 896 and a 0411 are virtually the same - both 512k byte PCM's. The only virtue in a 0411 is that it logs things slightly faster.
Rick
[QUOTE=B52Bombardier1;80084]From what I'm told, an 896 and a 0411 are virtually the same - both 512k byte PCM's. The only virtue in a 0411 is that it logs things slightly faster.
Rick[/QUOTE\ So RICK
FLASH a different Os to it closet to what it is witch should be not hard to figure out
Hello,
Yes - they both have red / blue connectors and the pin outs are the same. I have two 896 PCM's and a 0411 PCM and all three can . . . and are . . . running the same software load in each.
Yes - I would give you a copy of what I have in each but that wouldn't work for you because my setup is different than yours. Also, these are running a custom OS from HP Tuners and there is no matching and publicly available XDF for it.
And finally, some slick lawyer could someday say that I'm giving away HP Tuner intellectual property and I really don't need that hassle.
Rick
Thank You For The offer but This is Just to learn more i have not done a 4896 at all,
and to be honest i pulled wiring dia. up on this truck too see if all was the same @ pcm .
So now i will Flash it tomorrow my bench harness is @ my shop
Bought truck cheap it has rotter rear frame but i have a truck with light roll over damage perfect frame
good package then sell sell sell.
Again THANK YOU B52Bombardier and everyone else who commented
Last edited by bigbill0679; 02-02-2020 at 11:15 PM.
Posting Permissions
Reply With Quote
Bookmarks