see old thread;
http://www.gearhead-efi.com/Fuel-Inj...ing-new-skills
see old thread;
http://www.gearhead-efi.com/Fuel-Inj...ing-new-skills
I believe it is 4" on the throttle body to 3.5" for the ducting.
The site I tried to post didn't give a link so it might get overlooked and I just remembered another one.
www.intakehoses.com
www.siliconeintakes.com
Pretty sure this is the one we used....
http://www.siliconeintakes.com/bendi...bow-p-147.html
The aluminum tubing a T bolt clamps are on their site also.
You're probably right Ed. I couldn't recall if it's 4" or 4.5" but the right size elbow like that will deform and fit the oval shaped throttle body just fine. And, an elbow like that will make the bend a lot shorter than using a straight coupler and an aluminum elbow.
Here is another early picture
Last edited by EDZIP; 12-06-2015 at 05:49 AM.
Bookmarks