Results 1 to 3 of 3

Thread: $31 / $0E 4L80 tables

  1. #1
    Electronic Ignition!
    Join Date
    Oct 2015
    Posts
    17

    $31 / $0E 4L80 tables

    I'm not quite sure which mask I'm going to use yet. I figure they both will have similar tables to control shift timing and pressure. For now I'd like to stick with $31 and firm up the shifts. I read a couple posts about "shift speed vs altitude gain". I'm still not sure what the final verdict was on that.

    Same me thing goes for enabling PE. I read a few things but didn't quite push me in the right direction.

    oh boy. This isn't my ole 7747 that's for sure!

  2. #2
    Fuel Injected! 1BadAction's Avatar
    Join Date
    Apr 2012
    Location
    Dallas, TX
    Age
    41
    Posts
    391
    don't mess with shift speed vs altitude. Just bump the pressure up.

    Because I was using the older force motor, I had to log the actual pressure and compared it to commanded pressure and modify my force motor tables so they both were close. Then I went ahead and bumped the pressure in the shift tables slightly higher to give me a firmer shift (but no where near harsh).
    94 Blazer, Turbo'd 350 TBI - DD
    1991 2500 Suburban Adventure truck - 4wd conversion, 4-link F/R, 582ci CNP Big Block with Terminator X EFI backed by a 6L90 and twin stick'd NP205 t-case
    2012 Porsche Panamera Turbo - Date night car :)
    1979 16' Action Marine/"Johnny Cash" Merc Bridgeport Champ Motor - Metalflake Maniac

  3. #3
    Electronic Ignition!
    Join Date
    Oct 2015
    Posts
    17
    Quote Originally Posted by 1BadAction View Post
    don't mess with shift speed vs altitude. Just bump the pressure up.
    What would you say your pressures are at? I made a small increase of 20psi to the "max pressure" and the "pressure vs tps" table. I didn't notice much difference. But I'm waiting on my TransGo kit in the mail so I probably shouldn't be messing with it too much.

    I had a 6.2 turbo diesel with 4L80 using a Quick1 trans controller. That thing was great! The truck had 4.56 years and a Detroit Locker. It would squeak 2nd if I stomped it. I guess I've been kinda looking for that again haha

Similar Threads

  1. 2009 T42 TCM 4L80
    By Lextech in forum OBDII Tuning
    Replies: 0
    Last Post: 01-01-2015, 09:10 PM
  2. 4L80 Perf tune?
    By Scrufdog in forum GM EFI Systems
    Replies: 7
    Last Post: 08-12-2014, 05:40 AM
  3. 99 k2500 5.7l 4l80 4x4 .bin
    By mg01074 in forum GM EFI Systems
    Replies: 0
    Last Post: 04-05-2014, 06:44 PM
  4. 4L80/4L85 swap pointers.
    By brian617 in forum GM EFI Systems
    Replies: 6
    Last Post: 11-05-2013, 11:30 PM
  5. 4L80 swap
    By 1leg in forum GM EFI Systems
    Replies: 2
    Last Post: 04-14-2012, 05:21 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •