Thanks for all this great work! I'm working to transition from LT1Edit/etc and would like to use EEHack along with adding wideband sensors to tune my VE's real-time after a full rebuild and cam swap.
Since i haven't used EEHack yet, I assume I run version 4.7, connect, download my existing program from the ECM before any of these steps you list above, or can I jump straight to 4.92?
THEN, I flash with 4.7 with insert patches checked and then read the bin back out. Then you say "apply all patches from the folder". How do I do that? I assume I am pulling in all the changes in your CSV file that was bundled with the 4.92 EEHack zip file; do I just go to the Settings/Advanced tab and point to your updated CSV, then does that "apply the patches"? Because then you say flash the new bin with 4.7.
And for this entire process when should I switch to running the 4.92 EEHack executable instead?
Thanks again for helping me get up to speed here.
I'm running a 94 Formula, bored/stroked/nitrous 402 LT1 with dry and wet kits plus nano nitrous setup, 6-speed.
E-Ticket
Bookmarks