How to Enable PE on $0E

[Scrufdog]

Been awhile since I messed with tuning and TunerProRT. Finally got some family issues handled and settled after a year of issues and it's time to get back to things. I installed long tube headers and dual 2.25" exhaust on my Suburban, also lost the cat (it ran away :P). Installed a 4 wire O2 sensor as well.

Fired up ALDLDroid and my INT and BLM are WAY off. So, got everything set back up and went for a nice long drive to tweak the tune. I noticed that if I floored it, PE never kicked in. I seem to remember seeing this at some point last summer, but I dont think I ever asked about it.

Once the VE tables are setup, I 'd like to turn on PE. I see lots of parameters in the scalars and tables, but I am unsure how to get it set up just right.

If anyone can guide me, that'd be great.

Thanks

I've attached the relevant files.

[Scrufdog]

Got that worked out, was messing with it today. Found a thread on here that helped.