I installed a G2 adaptor and zif socket on my 1227747 ecu and put the stock chip back in to test the installation. The chip and ecu ran fine before I modified it but now I get a CEC light that doesn't flash and tuner pro can't ever connect with the ECU. Is there any obvious things to check in how I installed the adaptor?The only odd thing installing was I noticed a capacitor (maybe a diode) right next to the prom that had one leg cut. I soldered it back together even though the ecm ran fine with it the original way. Now I'm unable to even read the chip in a moates APU1. I can accept the fact I might have bricked the chip, but want to make sure the ECM hardware is actually connected correctly.Any advice?