Need help making my tune work with 2 bar map

[GHOSTOWLGRID]

I have a 1990 Chevy Beretta.

I swapped in a 3.1L LG5 turbo v6 and a 4T60-HD transmission. and did some modifications.
I removed the EGR, made it a 160 degree thermostat that works, and it has air conditioning.
Had the turbo upgraded from T25 to T28 as well.

The engine and trans came out of a 1990 Pontiac Grand Prix McLaren.

I made a tune for the Beretta, but I learned that it will not work because the Beretta EPROM code is made for a 1 Bar MAP.
My car has a 2 Bar MAP installed. The Grand Prix EPROM runs the car.

I have the car set to 11 PSI at the moment, I plan to up this to 13-14 PSI later. (I do not plan on exceeding the 2 bar map capabilities).
I have been using tuner pro up to this point. I was told that $8D is my best bet, however it does not have enough columns to be able to go up to 180-190 kpa in increments of 10, and it has extra items that I do not understand how to change.

The reason for my post is I need help making my bin file work with a 2 bar map and see boost up to 14.7 PSI.

I attached a copy of the bin file I have been making, feedback and assistance is welcome.
I have no prior expierence with any of this, I have been working mostly from 2 working examples to make a combined working version.