so im adding an electric fan and would like to have my 7427 pcm control it. i found the table to enter in the hex editorbut not clear on what to do after that.
so im adding an electric fan and would like to have my 7427 pcm control it. i found the table to enter in the hex editorbut not clear on what to do after that.
What mask are you using? Is it $0D, $0E, $E6 or $31? I hand edited my bin and entered the code using the hex editor. It works great in $0D. After you enter the code, you have to wire in a fan relay. The PCM turns on the ground side of the coil for the fan relay to make the fan run with the temps you set in the code. Which fan code are you wanting to use?
I'm using $0D mask and tps,soft start,transmission fan code I entered it into the hex editor and I understand I have to wire the ground for my fan relays to pin E3 but where do I adjust on off temps in tunerpro
1994 3500 Dually , 502 (509) , 264HR , Edelbrock MPFI , PFI '7427
1992 S-10 434 SBC/Tremec - '7427
1986 Monte Carlo SS
1984 S-10 , SAS, 496/700R4/205 , D44/14BFF -'7427
1980 Z-28 496/700R4
1979 Corvette 496/700R4
1977 Olds 98 Regency 403/700R4
I think I have that xdf don't have my laptop with me if it is the same xdf when I opened it all I saw was the fan controls do I use it for the fans then switch xdf for everything else
that was not the xdf I had I tried downloading the xdf you posted but I get a php file I am totally lost now
Right click the link and save as....
I tried that still getting a php file and windows wont open it
1994 3500 Dually , 502 (509) , 264HR , Edelbrock MPFI , PFI '7427
1992 S-10 434 SBC/Tremec - '7427
1986 Monte Carlo SS
1984 S-10 , SAS, 496/700R4/205 , D44/14BFF -'7427
1980 Z-28 496/700R4
1979 Corvette 496/700R4
1977 Olds 98 Regency 403/700R4
changed the file extension now when I try to select that xdf tunerpro comes back with an invalid xdf
What Operating System and browser are you using?
Windows 7 and internet explorer
I have no problem saving the link from Linux using Firefox or XP using IE. There is nothing wrong with the xdf file posted above by Nasty-Z.
I'm sure there is nothing wrong with the xdf it's something I'm doing wrong now any bin or xdf I try to download from gearheadefi comes up a php file I'll have a friend who does IT work look at it tomorrow I have no idea what to do now
Try Chrome or Firefox, I've given up on IE.
1973 K-5 Blazer, TBI 350, TH400, 1 ton axles & 38" SSRs'
1975 280Z, TBI 350, 700R4
1953 M-38A1, TBI Buick 231
1951 Ford Panel, 5.3 with 4L80E
Bookmarks