I am wondering if anyone has done any extensive bench flashing with the GM MDI/Tech 2 or other J2534 unit. I have heard that it doesnt become a problem until you start programming modules around 2012 and newer. After that supposedly the computers have to be in the vehicle. I was wondering if anyone could confirm this.
I am looking at getting setup with something to do factory flashing. If you guys have any recommendations, I am open to opinions, and suggestions.
Bench flashed up to 2015. Just have to be sure your comms termination is correct. Newer ECMs require 3-4 times the amperage to flash, be sure you have a converter that can handle it.
Are you using an mdi? What convertor are you using. I am just using a 1 amp wall adapter right now and have never had any trouble benchflashing using hp tuners up until about 2013 or so. Dont know if Ive done anything newer than that on a bench.
I found a high amp converter just laying around my junk pile. I dont remember what it was from.
Flashing we are using MDI, Cats, Efi, HP. Mostly using the MDI to burn a new clean GM tune then pull with other software and tune.
I have a Tech2 with an old tis cd along with a China dongle it works better than my mongoose and sps subscription. I'm using a radio shack 12v converter for like cb radios. I've had a couple not flash all the way with the mongoose cable sps ONLY on older LS1 style ecms.
What year does the tech2 have coverage up to? You still have to pay for a subscription with the tech2 dont you? I didnt think there was any way of working around that one.
I was going to try to get a hold of the TIS2000 software but I cant seem to find it. Even if I did im not sure if it would work with the mdi or if I would need to buy a tech2.
Posting Permissions
Reply With Quote
Bookmarks