Hello,
I am sure this is being posted in the wrong area, but being my first I thought it should go here.

New to the site, have been looking through the forums as a guest for some time. I am actively looking for more information on xdf and bin files for a 2008 2.4l ecotec engine with a mefi 5 box.

more specifically, any data to support an issue with the controller cutting the rpm at 8000 rpm. In my .bin, I have the rev limiter set at 8800 and clamp limit set to 8500.

Our motor is mechanically built to handle the increase in RPM, so I am convinced it is an electronic problem.

Any info/advice/trolling would be apreciated.

Thanks,
- Bobby w/ Jet Motorsports