Doesn't sound that bad Dave! 2 ECM stack easy and RBob has it dialed in!
RBob I had read a rumor of a new EBL with trans controls for this type situation. Any truth to that becoming a reality?
Doesn't sound that bad Dave! 2 ECM stack easy and RBob has it dialed in!
RBob I had read a rumor of a new EBL with trans controls for this type situation. Any truth to that becoming a reality?
1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
-= =-
I'm not trying rush the R&D of the '427 product development. I will simply state, I would be customer of a '427 based product that allows full functionally of either the 4L60E / 4L80E and full functionally of EBL Flash / EBL Flash P4 in one computer! I'm really liking the idea that I could use jumpers to operate TBI / Dual TBI / TPI / MPFI with or without Boost with the factory knock filter! I know, I'm asking for tooooooooo much in one product?
dave w
Doober, that's easy without boost. I have posts over at FSC with hex patches and whatnot for $0d. I've run a '01+ eccc 4l80e for some time now on the 8625. 8625 is a 7427 with TIS inputs, but the TIS is not required. I don't even need the TIS input with $0d_maf for tranny VSS (MAF needs that VSS pin), I just patched the bin to use the regular VSS input in the tranny code (it works fine).
I should probably consolidate all my 7427 patches onto this site and maybe delcohacking... one of these days =).
Now, where it's really at is CNP support. You could put eDist out of business by doing proper dwell calculations. Doing this on the stock 7427 hardware is no small hack, but it is "possible" if you re-purpose the tranny pins and write the code. I've looked into it, there is an available interrupt with unused pin for 1x cam signal (certain 4cylinder applications). But, then I'd also want to support LSx motors and a 24x CKP signal is probably too much for our beloved 2mhz chip to handle.
0411 would need hardware & software hacking to run TBI (injector drivers)...
RBob, are you hiring..? =). I'll email you one of these days..
Last edited by helo; 02-03-2013 at 08:10 PM.
Bookmarks