Results 1 to 4 of 4

Thread: Disable cat test on 0411, anyone know how?

  1. #1
    Fuel Injected!
    Join Date
    Jun 2013
    Posts
    199

    Disable cat test on 0411, anyone know how?

    shortly after startup when you have the post o2 sensors disconnected the 0411 pcm does a cat test going to 9:1 then 16:1 to look for results. HPT does not offer a way to shut this off, not sure if there is? Wondering if anyone knows if this can be disabled and where I might look?

  2. #2
    Fuel Injected! roughneck427's Avatar
    Join Date
    May 2012
    Location
    Fresno CA
    Age
    48
    Posts
    271
    All I know of is the cat diagnostic over temp. I usually zero out the fuel adder and in check the diagnostic test.

  3. #3
    Fuel Injected!
    Join Date
    Jun 2013
    Posts
    199
    Quote Originally Posted by roughneck427 View Post
    All I know of is the cat diagnostic over temp. I usually zero out the fuel adder and in check the diagnostic test.
    There is a master on/off for this in hpt and I zero out the fuel adder as well, does not stop this. Only happens when secondary o2s are taken out, if they are installed with no cats does not happen. Must be a switch for it I just don't know where to look.

  4. #4
    Fuel Injected!
    Join Date
    Feb 2013
    Location
    Euless, TX
    Posts
    2,308
    Quote Originally Posted by mecanicman View Post
    There is a master on/off for this in hpt and I zero out the fuel adder as well, does not stop this. Only happens when secondary o2s are taken out, if they are installed with no cats does not happen. Must be a switch for it I just don't know where to look.
    I will be watching this just in case I tune one without rear o2s or cats someday. Probably has a switch hidden in the code somewhere. Adam aka Dimented24x7 on Thirdgen.org might be able to shine some light on the code aspect of this problem depending on what operating system you are running.

    This sounds similar to the old Forced Knock Test of the 7747. The first timing bump was 12* over commanded. If it didn't knock, phase 2 of the test was 22*. If you had an inoperative knock sensor and a hotter engine. Sounded nasty under the hood from all the clattering.
    Last edited by Fast355; 07-09-2015 at 03:49 PM.

Similar Threads

  1. How do I disable PE?
    By majacoby in forum GM EFI Systems
    Replies: 16
    Last Post: 11-23-2017, 08:40 PM
  2. Procedure to disable EGR
    By Chewy1576 in forum GM EFI Systems
    Replies: 2
    Last Post: 03-20-2015, 07:05 AM
  3. Help with 1993 corvette disable comms
    By 1320_john in forum GM EFI Systems
    Replies: 7
    Last Post: 07-08-2014, 06:35 AM
  4. Disable the 9th injector
    By MYLTWON in forum TunerPro Tuning Talk
    Replies: 4
    Last Post: 06-19-2013, 04:20 PM
  5. Checksum disable ('165), TP5
    By dyeager535 in forum GM EFI Systems
    Replies: 4
    Last Post: 07-24-2012, 06:32 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •