Another option for $0D efan control

[PJG1173]

ok got wires added to the ecu loaded the code for fan A and B. did not do the soft start. Using a volt meter I am monitoring for ground on E3 and e7. I am showing a ground for fan A. no ground on fan b. engine is not up to temp and no thresholds have been reached that should have activated fan A. this is what I have set


Fan A calibration
Overheat temp for fan on 209.8
Temp for fan on 194.9
Temp for fan off 185.5
MPH for fan off 60
TPS for fan on 14.8
minium fan run time 30 sec
use fan a with a/c set
fan b calibration
Overheat temp for fan on 215
Temp for fan on 185.5
Temp for fan off 177.4
MPH for fan off 55
TPS for fan on 99
minium fan run time 20 sec
use fan a with a/c not set


If i leave Overheat temp for fan on for fan B at -40 it will show ground on that pin. I'm going to keep messing with the settings to see if I can get fan A to work.